REXI frameless glass shower are distinguished from other ordinary shower by the fact that there are no consolidated frames around the glass. It is generally made of 8 to 12mm tempered glass, with a decorative frame upside and downside, or directly with a clip on one side and a buried spring on the ground.
China frameless glass shower suppliers do the installation using a glass sucker (or sucking machine) to suck and hold the thick glass, and then hold the suction cup to lift it by 2-3 persons and stand upright to move to the installation site to be in place. Positioning method: insert the upper part into the limiting groove at the top of the door, then place the lower part on the centerline of the bottom support, and install the position so that the sides of the thick glass are just right. The metal fittings that seal the door frame face the seam, and it is required by China frameless glass shower manufacturers that both the inside and the outside cannot see the decorative seam joint.
In the bottom of the wood on the inside and outside the nail two flat square bar sandwiched between, leave a gap of about 4mm from the plate, and then in the flat square bar coated with all-purpose adhesive to decorate the metal plate. Stick in the square wood and the two flat square sticks.
China frameless glass shower factory injects glue into the gaps on both sides of the top groove and on both sides of the bottom notch, which determines the frameless glass shower price. And between the thick glass and the door frame column. The injection sequence should start from the end of one gap to the end and must not stop in the middle. After filling, the plastic sheet is also used to scrape the glue so that the gap forms a clean uniform straight line. The glue trace on the frameless shower glass surface should be cleaned completely.